Blending/Carding Board

The Wingham Blending Board is simple, quick and effective way of making your own fibre blends at home.
Comes as a complete kit to get you going.
Adjustable to get the best angle for blending and carding.

It has been designed o have all the fittings needed to get the best out of blending and carding.

To blend fibres

Place your mix of fibres onto the board and with the reverse carder provided brush the fibre down into the wire. Continue layering fibre onto the wire until a good covering is made. Don't overdo it as the resulting batt can be too thick.
Take the two dowel sticks together and trap the top fringe of fibre between them. Begin rolling downwards creating a tube of fibre, rolag, until you get to the bottom. Its a lift and roll action. When finished the dowels will pull cleanly out of the fibre. 
If you are making a felting batt simply load up the carder wire brush down with the reversed carder and then by running a knitting needle through the wire it will lift off in one sheet.

Carding fibres

It can also function as a carding board if used along with a full size hand carder. Simply place washed fleece fibres to be carded onto the board and use a full sized hand carder to card with. When fully carded use the dowel rolag sticks to remove the fibre from the board as with the instructions above.

Specification

At the rear of the board you'll find a supporting brace that can be fixed in three different positions, adjusting the working angle that the board sits at when table mounted. For storage it can be removed completely.

Two clamps are supplied to keep everything sturdy and in place when working on a table top, giving a stable working platform to create your blend. 

The carding area covers 30cm x 30cm and is made of the same specification card cloth that we use for our Wingham Hand Carders. This 72 PPI cloth is suitable for most wool types that you'll be using, though if you aren't sure if it's right for what you intend on using then feel free to contact us in advance.

Weight: 2.8kilos, a good weight to give stability
Carry handle slot
Stainless steel carder wire for easy care and non rusting 72 TPI wire
Birch faced ply board for stability, no warping
Adjustable 3 position keel for varying the table angle
The keel can be rotated so that the board can be placed on your lap and gripped between youe knees.
Table edge clamping points and clamps for secure fixing.
Mini carder with reversed wire  to enable fibre to be brushed down into the blending board.
A pair of dowels for rolling off the fibre into rolags.

It can be used as a carding board by using a full sized hand carder against it. 
Set the board up, load it with washed fibre as you would a handcarder. Card the fibre with a full sized hand carder. To take the fibre off use the pair of dowels to roll into rolags. We suggest if carding fleece you load it with less than you would for blending. For good carding results less is better to make lightweight rolags.